One of the most important aspects of safety at home is high security locks. These blocks can be at any hardware store, online or off-line to find. Price may vary considerably from brand but all the safe door locks, some of the basic components are: solid, hardened steel cylinder guard, cemented screws and bolts, which protrudes at least 1 cm from the edge of the door.
When you buy your new lock on the door, you should have noticed a pattern. This model shouldLabeling leads to different thicknesses. Take the pattern and fold it to make sharp edges along the lines of the size of the door. They are then located about 6 inches above the door handle existing and paste them on the door. If the model has locked the door a sharp object, preferably a nail and mark the screw hole and a hole for the lock. Once the votes have been, you delete the template.
Then just close the door so that it remains quiet, with an electric drilland a hole saw the hole needed to slow down the door. You may need to stop the drill several times to avoid splitting wood on the edge of the hole. Make sure that if little is pushed through the door to go outside the door and finish the hole.
Once the appropriately-sized hole in the door you need to open it then made wedge. With a bit of wood to make holes for the block. Next slide the cap into the screw hole. Make sure the screwFlush-mount and mark the outline of the front panel. With a chisel to cut a hole for the front panel. Make sure you just enough room for the chisel flat front. Replace the front plate and pass the final stages.
It is time to insert the disk to the bar in its place, note the guide bar may be too large, can be cut, if necessary. Insert the guide rail and then the assembly block. If the unit does not prevent the re-assembly to rotate 180 degrees. If the rotationRemove the drive can rotate the lock bar free assembly and installation of the mounting plate. Replace the block and tighten the screws using snap your disposal.
0 comments:
Post a Comment